Component Suppression
State in Configurations
The column header in a design table to control the suppression
state of a component uses this syntax:
$STATE@component<instance>
The column header is not
case sensitive.
In the table body cells, type the value for the desired suppression
state: Suppressed (or S),
or Resolved (or R).
You cannot set a component to the lightweight state. If a cell is left
blank, the default suppression state is Resolved.
If the component
uses a derived configuration, and the table body cell is left blank, the
value of the component suppression state used is linked to its parent.
Example of a design table that controls the suppression state of a component:
![](../art_local/design_table_component_suppression.gif)
You can also right-click
a component and select Configure
component to configure the suppression state of the component.