Hide Table of Contents

Edit Flattened Route PropertyManager

You can make changes to flattened routes by dragging entities and constraining them. These changes are not applied to the 3D configuration.

Make geometric changes (such as adding or deleting branches) in the 3D configuration, and the flattened configuration updates.

To edit a flattened route:

  1. Activate the flattened route by right-clicking FlattenedRoute and selecting Show Configuration.

  2. Right-click the flattened route and select Edit Flattened Route.

  3. Use the tools in the PropertyManager to make changes.

  4. Click .

Edit Tools (Annotation)

Tool

Description

Example

Drag. Enables you to drag any sketch point or line in the flattened sketch. Select Flip Selection to select the complementary segments on the other side of the sketch segment.

 

Horizontal. Constrains the selected segment horizontally, and enables you to toggle the segment between horizontal positions.

Vertical. Constrains the selected segment vertically, and enables you to toggle the segment between vertical positions.

Delete Relations. Removes the horizontal or vertical constraint on a sketch segment, so you can position the segment at an angle. After you delete relations, click Drag to reposition the segment.

Edit Tools and Formboard Edge Location (Manufacture-Style)



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Editing a Flattened Route
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.