Hide Table of Contents

Display States in Parts

A part's display settings are stored in display states in the part.

Part display states control the appearance, display mode, hide/show, and transparency of bodies, features, faces, and parts as shown:

  Hide/Show Display Mode Appearance Transparency
Parts     X X
Bodies (solid and surface) X X X X
Features     X X
Hideable features such as sketches, reference geometry, curves, parting lines, and routing points X      
Faces     X X

To view display controls, click at the top of the FeatureManager Design tree to expand the Display Pane.

Display Pane closed Display Pane open

From the Display Pane, you can define different combinations of the settings and save them in display states.

Display State-1 Display State-2

You can use the Display Pane to:


  • Change display settings for a part's features and solid and surface bodies.
  • Change the appearance of the part.
  • Add new display states to the part.
  • Rename display states.
  • Change the active display state.
  • Remove all or selected appearances from the part.

You can also control the display state mode by linking display states to configurations in the ConfigurationManager.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Display States in Parts
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.