Hide Table of Contents

Hiding and Showing Components Using the Tab Key

In the graphics area, you can press Tab and Shift + Tab to hide and show components of an assembly.

To hide a component:


  • Move the pointer over a component and press Tab.

To show a component:


  • Move the pointer over an area containing a hidden component and press Shift + Tab.

You can use these commands regardless of the component's state (resolved, lightweight, SpeedPak, or Quick view). The commands are not available when another command is active.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Hiding and Showing Components Using the Tab Key
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.4