Hide Table of Contents

Switching All Subassemblies to SpeedPak

When opening an assembly, you can use the SpeedPak configuration instead of the last-saved configuration for all subassemblies.

  1. Click Open (Standard toolbar) or File > Open .
  2. In the Open dialog box, select Use SpeedPak.
  3. Click Open.

    For subassemblies whose last-saved configuration is the parent of a SpeedPak configuration, the SpeedPak configuration is used.

    After an assembly is opened, you can switch subassemblies back and forth between a SpeedPak configuration and the SpeedPak's parent configuration. See Switching Between SpeedPak and Parent Configurations.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Switching All Subassemblies to SpeedPak
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46