The sequence of diagnosis error messages for fillets is as follows.
Contents
A fillet never has a planar face.
Fillet geometry must smoothly merge into the adjacent faces.
The fillet face has the same radius as an adjacent face.
The radius of the fillet face is too large.
The radius of the curve across the fillet is greater than the radius of the edge along which the fillet is modeled.
The edge of the selected face is not valid for a fillet face.
The angle between the support faces is too small.
FeatureWorks does not recognize vertex fillets.
The selection is not valid for fillet recognition.
The face does not represent a valid fillet.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2013 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.