Hide Table of Contents

List Thermal PropertyManager

You can list temperature and heat flux results after you run a Thermal study.

To access this PropertyManager, after you run a Thermal study, right-click Results and select List Thermal.

Component

Units Select the units of the component.
Component Sets the thermal component to be searched for extreme values. The default is to list values within 5% tolerance of the Absolute Max value. Select from the list of available thermal components.

Thermal Components
Time Step Number Available for transient thermal analysis. Sets the time step at which results are to be listed. Default step is 1 for steady state thermal analysis.

Advanced Options

Plane, Axis or Coordinate System Select a reference plane, an axis, or a coordinate system to list stress. Used for directional components only.
Extremes Select this option to search for extreme values.
Criterion Sets the criterion for extreme values of results. Available list options are:
  • Absolute Max
  • Algebraic Max
  • Algebraic Min
  Sort by value Activates the sorting of the list.
  List all values within Sets the range of values to be listed. The default is to list values within 5% tolerance of the extreme value.
Range Use this option to list values sequentially with node numbers. Enter the lowest and the highest node numbers.

List Set

Available only if Range is selected under Advanced Options.

Lists temperatures and gradients Lists nodal temperature, the three components of temperature gradient , and the resultant temperature gradient.
List heat flux Lists the three components of heat flux and the resultant heat flux.

Contents

  • Thermal Components

  • Heat Power/Energy PropertyManager

    The Heat Power/Energy PropertyManager lists the heat power or heat energy of the thermal equilibrium calculations. It also lists the net heat power or heat energy that is entering or leaving the system. Listing of heat energy is available for transient thermal studies only.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   List Thermal PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20