Hide Table of Contents

Example - Adding a Route Line

In this example, a route line is added between a pin and a hole in a shaft in an exploded view.

To add a route line:

  1. Select one face, circular edge, or straight edge on each of the two items you want to connect.

    For example, select the face of the hole and the circular edge of the pin:


    explode_sketch_route_2.gif

    A preview of the route line appears.


    explode_sketch_route_3.gif

  2. Click PM_OK.gif.

    The route line appears.


    explode_sketch_route_4.gif

    The Route Line tool stays active so you can insert multiple lines.

    All lines in an explode line sketch appear in phantom font.

  3. Add more route lines, or click PM_OK.gif again to close the PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example - Adding a Route Line
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46