Hide Table of Contents

Trimming with Trim Away Inside

Trims open sketch entities that lie inside two bounding entities.

To trim with the Trim away inside option:

  1. Right-click the sketch and select Edit Sketch.
  2. Click Trim Entities Tool_Trim_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Trim.
  3. In the PropertyManager, under Options, select Trim away inside PM_trim_trim_away_inside.gif.
  4. Select two bounding sketch entities.
  5. Select the sketch entities to trim.

    The sketch entities you select to trim must either intersect each bounding entity once, or not intersect the two bounding entities at all.

  6. Click PM_OK.gif.

    Video: Trim Away Inside



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Trimming with Trim Away Inside
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46