Hide Table of Contents

Adding Edge Flanges

  1. In an open sheet metal part, click Edge Flange Tool_Edge_Flange_Sheet_Metal.gif (Sheet Metal toolbar) or Insert > Sheet Metal > Edge Flange.
  2. In the graphics area, select one or more edges for Edge PM_sheetmtl_Edge_Flange_Edge.gif.

    There are specific requirements for adding edge flanges to curved edges. See Edge Flanges.

  3. Set options in the Edge-Flange PropertyManager and click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Edge Flanges
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46