Hide Table of Contents

Applying Illumination, Surface Finishes, and Texture Mapping

Once you apply appearances to a model, you can further customize your output by selecting functions from these tabs in the Appearances PropertyManager:

Illumination PM_Illumination_tab.gif

The illumination properties of appearances combine the colors of a point on a model with the light arriving from light sources that surround the model.

Surface Finish PM_Surface_Finish_tab.gif

The surface finish properties of an appearance determine the roughness of the surface.

Mapping PM_Mapping_tab.gif

Textures are appearance properties. When you apply textures to geometry in SolidWorks models, you need to change the appearance definition. SolidWorks provides several texture mapping techniques.

Only textural appearances have editable texture properties.

To apply illumination, surface finish, and texture mapping properties:

  1. Click the Appearances, Scenes, and Decals tab_Appearances.gif tab in the Task Pane.
  2. From the Appearances appearances_folder.gif tab , browse through the appearance folders on the top pane.
  3. Select a preview from the bottom panel.
  4. Alt + drag a preview to display the Appearances PropertyManager, then click:
    • Illumination PM_Illumination_tab.gif
    • Surface Finish PM_Surface_Finish_tab.gif
    • Mapping PM_Mapping_tab.gif
  5. Apply the properties from each tab and click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Applying Illumination, Surface Finishes, and Texture Mapping
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46