SOLIDWORKS uses a system of coordinate systems with origins. A part document contains an original origin. Whenever you select a plane or face and open a sketch, an origin is created in alignment with the plane or face. An origin can be used as an anchor for the sketch entities, and it helps orient perspective of the axes. A three-dimensional reference triad orients you to the X, Y, and Z directions in part and assembly documents.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2015 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.