Hide Table of Contents

Grid and Snap

SOLIDWORKS snaps to sketch geometry on the fly. For example, as the pointer approaches a line endpoint, the pointer changes to recognize the endpoint so you can choose to select it.

SOLIDWORKS offers a display grid and snap grid while in sketch mode and in drawings. You can align the grid to a model edge and you can snap to an angle. The grid and snap capabilities are not often used in SOLIDWORKS since dimensions and relations provide the required accuracy.

 
Grid with snap in a sketch   Grid aligned to a specified model edge


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Grid and Snap
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46