> Simulation > Loads and Restraints > Thermal Loads and Restraints > Heat Flux

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Design Studies in SOLIDWORKS

Detailing and Drawings

Welcome to SOLIDWORKS Simulation Help

Accessing and Using Help

Legal Notices

SOLIDWORKS Simulation Reference

SOLIDWORKS Simulation Fundamentals

Workflow for Performing 2D Simplification

Composite Shells

Loads and Restraints

Directional Loads and Restraints

Multiple Application of Displacement Restraints

Thermal Loads and Restraints

Transient Thermal Stress Analysis

Summary of Thermal Boundary Conditions

Interaction of Thermal Studies with Other Studies

Importing In-mold Stresses from SOLIDWORKS Plastics

Analysis Library Features

Viewing Analysis Results

Study Reports

Factor of Safety Check

SOLIDWORKS Sustainability

Heat Flux

The Heat Flux PropertyManager lets you apply heat flux to the selected faces. Heat flux is used in thermal studies only. For steady state thermal studies, you can define temperature-dependent heat flux. For transient thermal studies, you can define time- or temperature-dependent heat flux, and a thermostat to control the heat flux.

Search 'Heat Flux' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Heat Flux
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

Just this topic

This topic and only immediate topics under it (up to 4 topics)

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.