Hide Table of Contents

Insert Line PropertyManager - 2D

Enables you to sketch multiple 2D lines. For each 2D line you sketch, you can select different combinations of settings under Orientation, Options, or Parameters.

To open the Insert Line PropertyManager:

In a sketch, click Line Tool_Line_Sketch.gif on the Sketch toolbar, or click Tools > Sketch Entities > Line.

Orientation

As sketched With the click-drag method, sketch a line in any direction until you release the pointer.

With the click-click method, sketch a line in any direction, and continue sketching other lines in any direction, until you double-click.

Horizontal Sketch a horizontal line until you release the pointer.
Vertical Sketch a vertical line until you release the pointer.
Angle Sketch a line at an angle until you release the pointer. The angle is created relative to the horizontal.

Options

All four line orientations under Orientation allow you to select either of the following under Options:

For construction Creates a construction line.
Infinite length Creates a line of infinite length that you can later trim.
Midpoint line Creates a line that is symmetrical from the midpoint of the line.

Parameters

Appears when you select any orientation except As sketched.
Some selections under Orientation and Infinite Length under Options override settings for Quick Snaps.
The following Parameters are available with the following Orientation.
Horizontal and Vertical

Length

Create a horizontal or vertical line at that length.

Add dimensions

Select to display the dimension.

Angle

Length

Create a line at an angle at that length.

Angle PM_angle.gif

Create a line at the angle specified.

Add dimensions

Select to display the dimension.

Once you sketch a line, the Insert Line PropertyManager changes to the Line Properties PropertyManager, and you can continue sketching with the same Orientation. To change Orientation, Options, or Parameters, click PM_OK.gif to return to the Insert Line PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Insert Line PropertyManager - 2D
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.