You can insert center marks in slots, include slots in hole tables, and display hole callouts for straight slots.
To insert center marks into slots whenever you create drawing views for parts or assemblies:
You can set up SOLIDWORKS to insert center marks whenever you create drawing views.
To automatically place center marks in slots at drawing view creation for parts or assemblies:
To place a center mark in a sketch:
You can apply hole callouts to straight slots. The slot dimensions appear in the callout.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2016 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.