Hide Table of Contents

Creating an Angle Mate With Reference Entity

To create an angle mate with a reference axis:

  1. Make sure that the two entities to mate are constrained directly or indirectly using concentric, coincident, parallel, or distance mates.
  2. Click Mate (Assembly toolbar) or Insert > Mate.
  3. In the Mate PropertyManager, for Entities to Mate , select two entities in the graphics area or the flyout FeatureManager design tree.
  4. Under Standard Mates, click Angle and set the dimension.
  5. Do one of the following:
    • Click Auto Fill Reference Entity .
    • Select a face or edge in the graphics area that is perpendicular to the two mated components.
  6. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating an Angle Mate With Reference Entity
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46