Hide Table of Contents

Sheet Metal

Contents

  • Cuts in Swept Flanges

    If you use a swept flange with cuts in the bend area, the cuts are mapped correctly to flatten geometry.

  • Edge Flanges

    You can create edge flanges that are longer than the edge to which they are attached.

  • Using Flattened Mass

    For sheet metal parts, you can choose Flattened-Mass in the Cut-List Properties and Summary Information dialog boxes. Flattened mass is calculated based on the model's flat pattern.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sheet Metal
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20