Specifying Modify Parameters for Simple Holes

The Modify: Simple Hole Parameters dialog box lets you specify new parameters for cylindrical or conical holes created as Simple Hole features. The following parameters are available:

  Depth Set a new value to change the hole depth.
  Diameter Set a new value to change the hole diameter.
  Modify Draft Select to remove drafts from the hole. Make sure Apply Draft is cleared.
  Apply Draft Select to change the hole's draft angle. Make sure Modify Draft is selected. To change the hole's draft angle, set a new Angle, and select either Only Inward or Only Outward to change the draft slope.
  Reverse Offset Select Any, On, or Off. (For Offset From Surface as End Condition only).
  Translate Surface Select Any, On, or Off. (For Offset From Surface as End Condition only).
You cannot change the End Condition during Modify.