Hide Table of Contents

Pasting Entities As Block from the Clipboard

Use the PasteAsBlock command to paste entities from the clipboard to the drawing as Block. A Block binds entities together to form a single entity. You can insert a Block whenever you need it in a drawing.

Copy entities from a drawing to the clipboard with the Cut, ClipboardCopy, or Copy@ commands, then paste copies of the entities into other open drawings.

To paste entities from the clipboard as Block:

  1. Click Edit > Paste as Block (or type PasteAsBlock).
  2. The clipboard contents are attached to the pointer.
  3. Type coordinates or click an insertion point for the clipboard contents.
  4. Specify the X and Y scale for the Block insertion.
  5. Specify the insertion angle.
  6. The entities are inserted as Block.

  The Block created using the PasteAsBlock command is named arbitrarily. To rename the Block inserted from the clipboard, use the Rename command.

Access

Command: PasteAsBlock

Menu: Edit > Paste as Block

Keyboard Shortcut: Ctrl + Shift + V

Keyboard Shortcut: Command + Shift + V

Related Topics

Copying to the Clipboard

Copying with a Base Point to the Clipboard

Cutting to the Clipboard

Pasting from the Clipboard

Using the Clipboard



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Pasting Entities As Block from the Clipboard
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20