Hide Table of Contents

Copying with a Reference Point to the Clipboard

Use the Copy@ command to copy selected entities and a reference point from the drawing onto the operating system clipboard.

From the clipboard, you can paste the entities into open drawings using the Paste and PasteAsBlock commands.

The entities selected with Copy@ remain on the clipboard until you place new entities on the clipboard.

  The Copy command copies entities in the drawing from a specified base point to target points within the drawing, but not to the clipboard.

To copy to the clipboard with a reference point:

  1. Click Edit > Copy with Reference Point (or type Copy@).
  2. Specify the reference point coordinates.

    The reference point is used as the insertion base point when you later paste the entities.

  3. Select entities to copy.
  4. Press Enter.

    The selected entities are added to the clipboard.

Access

Command: Copy@

Menu: Edit > Copy with Reference Point

Keyboard Shortcut: Ctrl + Shift + C

Keyboard Shortcut: Command + Shift + C

Related Topics

Pasting from the Clipboard

Pasting Entities as Block from the Clipboard

Copying to the Clipboard

Cutting to the Clipboard

Copying Entities in the Graphics Area



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Copying with a Reference Point to the Clipboard
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20