Hide Table of Contents

Creating Linear Dimensions

The LinearDimension command creates horizontal, vertical, and rotated linear Dimensions.

To create linear Dimensions:

  1. Click Dimension > Linear (or type LinearDimension).
  2. Specify the first and second extension line origins.

    - or -

    Press Enter, and specify an entity to dimension. You can specify Lines, PolyLines, Circles, and Arcs. The start and end points of linear entities, or the diameter of circular entities are measured.

  3. Specify the position of the dimension line or specify an option:
    • Angle, Note, or Text: See Editing and Formatting Dimension Text. To dimension the real length of Lines not parallel to the X- or Y-axis of the coordinate system, use the ParallelDimension command.
    • Horizontal: Creates a horizontal linear Dimension. The horizontal distance between the defining points is measured and the dimension line is parallel to the X-axis.
    • Rotated: Creates an oblique Dimension about an angle you specify for the dimension line. The distance between the defining points is measured along the specified rotation (parallel to the oblique dimension line).
    • Vertical: Creates a vertical linear Dimension. The vertical distance between the defining points is measured and the dimension line is parallel to the Y-axis.

    The measurement is placed as Dimension text based on the definitions of the current DimensionStyle.

Access

Command: LinearDimension

Menu: Dimension > Linear



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Linear Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.