Hide Table of Contents

Fillet

Menu: Draw > Fillet

 

Manages the intersection of two lines by placing an arc of a specified radius.

 

Pins the command, ensuring that the command remains active after it is first used.

Stops the command after it is first used.

Ends the command.

Returns to the previous interface.

 

Adjust/Do not adjust: Allows to cut (not cut) the lines at the arc ends.

Modify radius: Allows to enter the arc radius.

 

Select the two lines to which you want to add the fillet.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Fillet
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46