Using Predefined Hatches

You can apply predefined hatches on geometry in the graphics area.

To use predefined hatches:

  1. Do one of the following:
    • On the ribbon, click Mechanical Contents > Tools > various hatch options.
    • Enter AM_PHatch at the Command window.
  2. Specify the predefined hatch pattern to use:
    Icon Single hatching size(inches) Angle (degrees) Spacing (millimeters)
    0.1 45 2.5
    0.22 45 5
    0.5 45 13
    0.12 135 2.7
    0.19 135 4.7
    0.4 135 11
    Icon Cross hatching size(inches) Angle (degrees) Spacing (millimeters)
    0.09 45/135 2.3
  3. In the graphics area, specify an internal point in an enclosed area of the geometry.
    The hatching is displayed and added to the drawing.

    Access

    Command: AM_PHatch

    Ribbon: Mechanical Contents > Tools > various hatch options.