In assembly drawings, you can use Alternate Position Views to indicate the range of motion of an assembly component by showing it in different positions.
You can overlay one or more Alternate Position Views on the original view in a phantom font.
- You can dimension between the primary view and the Alternate Position
View.
- The Alternate Position View is added to the FeatureManager design
tree.
- You can create more than one Alternate Position View in a drawing.
- The Alternate Position View is available in
crop views and
broken-out section
views, but not for
break views or section views.
- After you create an Alternate Position View, you can modify it at
the assembly and drawing levels.