Hide Table of Contents

Solid Mesh

In meshing a part or an assembly with solid elements, the software generates one of the following types of elements based on the active mesh options for the study:

  • Draft quality mesh. The automatic mesher generates linear tetrahedral solid elements.

  • High quality mesh. The automatic mesher generates parabolic tetrahedral solid elements.

Linear elements are also called first-order, or lower-order elements. Parabolic elements are also called second-order, or higher-order elements.

A linear tetrahedral element is defined by four corner nodes connected by six straight edges. A parabolic tetrahedral element is defined by four corner nodes, six mid-side nodes, and six edges. The following figures show schematic drawings of linear and parabolic tetrahedral solid elements.

Linear solid element

Parabolic solid element

In general, for the same mesh density (number of elements), parabolic elements yield better results than linear elements because: 1) they represent curved boundaries more accurately, and 2) they produce better mathematical approximations. However, parabolic elements require greater computational resources than linear elements.

For structural problems, each node in a solid element has three degrees of freedom that represent the translations in three orthogonal directions. The software uses the X, Y, and Z directions of the global Cartesian coordinate system in formulating the problem.

For thermal problems, each node has one degree of freedom which is the temperature.

CAD model of a part

Model meshed with tetrahedral elements

High quality mesh is recommended for final analysis.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Solid Mesh
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.