Hide Table of Contents

Ribbon Cables

You can model flexible or folded ribbon cable routes.

Flexible Folded
To create ribbon cable routes, you need:
  • Ribbon cable connectors and clips. You can create your own ribbon cable connectors and clips or use the sample parts provided in the Design Library. Use clips and virtual clips to define the path of the route. To access sample connectors and clips, go to the Design Library tab of the Task Pane and browse to routing\electrical\ribbon cable.
  • Ribbon cable. You can define your own ribbon cable, or use the sample cables provided in the cable/wire library. Click Routing > Electrical > Open Cable/Wire Library. In the dialog box, select Ribbon Cable Library to see the predefined cables or to add your own.
To route a ribbon cable:
  1. Pre-place ribbon cable clips and connector sockets in the main assembly.
  2. To start the ribbon cable route, insert a valid ribbon cable connector into the main assembly.
  3. Using Auto Route (Electrical toolbar), specify the path by selecting connectors and clips.

See Creating Flexible Routes and Creating Folded Routes.

The following are limitations within the ribbon cables environment:
  • Internal connectivity is not supported. Therefore, you cannot assign wires, you cannot use from-to lists, and connector tables do not show any connectivity.
  • You must use the Auto Route PropertyManager to specify the path for ribbon cable routes. You cannot use tools from the Sketch toolbar and menus.
  • Re-route spline is not available in the Auto Route PropertyManager. You must set up route geometry prior to routing, by pre-placing clips and connector sockets.
  • The Repair Route command is not supported.
  • Use of fixed-length standard cables is not supported.
  • Drawings of the flattened route do not show inline connectors. (You can show inline connectors in drawings of the 3D model of the route.)


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Ribbon Cables
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.