Hide Table of Contents

Auto Route

The Auto Route tool automatically creates route geometry. In the case of electrical Routing, a spline is generated to connect the short stub lines of the connectors and create a route.

Auto Route enables you to:
  • Route automatically through existing geometry in the 3D route sketch.
  • Route automatically through certain objects that are outside the route sketch.
  • Update routes to travel through selected clips.
  • Update routes to travel through any axis.
  • Display guidelines that show wires from imported from/to data, manipulate those guidelines, and convert them into routes.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Auto Route
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.