Electrical Connectors
You can use electrical connector parts supplied with the software, or create your own parts. Follow these steps to make connectors.
- Placement of Electrical Connectors
- Connection Points for Electrical Connectors
A connection point is a point in an electrical connector where a cable begins or ends. Electrical connectors are required to have at least one connection point with the route type set to Electrical. This defines the part as an electrical connector and provides information about the route.
- Creating Electrical Connectors
- Creating Custom Connector Tables Templates
Routing connector tables are general tables defined by .sldtbt templates. Generate a custom connector table from a valid custom connector table template or modify the connector table generated by the default template. You must retain the default connector table columns in custom connector tables.
- Customizing Connector Tables
Routing connector tables are general tables defined by .sldtbt templates. Generate a custom connector table from a valid custom connector table template or modify the connector table generated by the default template. You must retain the default connector table columns in custom connector tables.
- Connection Point PropertyManager
The Connection Point PropertyManager appears when you create a connection point in a routing fitting (flange, elbow, electrical connector, etc.).