Hide Table of Contents

Creating Single Reference Points

To create a single reference point:

  1. Click Point on the Reference Geometry toolbar, or click Insert > Reference Geometry > Point.
  2. In the PropertyManager, select the type of reference point to create.
  3. In the graphics area, select the entities to use to create the reference point.
    You can create reference points at the intersections of the following entities:
    • An axis and a plane
    • An axis and a surface, both planar and non-planar
    • Two axes
  4. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Single Reference Points
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48