Hide Table of Contents

Modifying Dimensions of One Instance

You can change the dimensions and position of one instance in a pattern.

  1. In the FeatureManager design tree, select Lpattern and right-click Edit Featurefm_edit_feature.gif.
  2. On the last instance in the row, do the following:
    1. Hover the pointer over the instance marker.
    2. Left-click and select Modify Instance.

    A callout appears in the graphics area and lists the instance in array format (5,1).

    If you select Skip Instance, the instance is removed from the pattern.

  3. In the Instance (5,1) callout, override the Width dimension by entering 12mm.

    wn2013_varydims_2

    To adjust the dimension and spacing values, hover over the instance marker, right-click and select Edit Modified Instance.

  4. Click PM_OK.gif.

The modified instance doubles in width.

wn2013_varydims_5



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Modifying Dimensions of One Instance
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.61