Hide Table of Contents

Overriding the Center of Mass Position

You can assign values for the coordinates of the Center of Mass (COM) point to override the calculated values.

This is useful when you create a simplified representation of a model and want to show the correct position of the center of mass.

To override the COM point coordinates:

  1. Click Mass Properties Tool_Mass_Properties_Tools.gif (Tools toolbar) or Tools > Mass Properties.
  2. In the Mass Properties dialog box, click Override Mass Properties.
  3. In the Override Mass Properties dialog box:
    1. Select Override center of mass.
    2. Enter values for coordinates X, Y, and Z.
    3. Optionally, for As defined in, select a coordinate system previously defined by you.
    4. Click OK.
  4. Close the Mass Properties dialog box.

    The COM point moves to the position you specified. The icon changes to center_of_mass_feature_overridden.gif to indicate that the point is user-overridden.


This example shows an industrial pressure switch that is modeled as a single solid part. In reality, the switch has a hollow enclosure with a heavy pressure connection extending off the side.

The COM point of the solid part is shown near the center of the enclosure. Because the enclosure is actually hollow, you know that the system-calculated center of mass is not accurate. Outside of the SolidWorks application, you determine more realistic coordinates for the COM point. Then you override the system-calculated coordinates with your more realistic values.

Calculated User-Overridden
COM_point_calculated.gif COM_point_overridden.gif

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Overriding the Center of Mass Position
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.