Hide Table of Contents

Using Design Clipart with SolidWorks Task Scheduler

To use Design Clipart with SolidWorks Task Scheduler:

  1. Create a dissection folder and place files to dissect there.
  2. Click Options Tool_Options_Standard.gif > File Locations. In Show folders for, select Search Paths. Add the dissection folder under Folders and click OK.
  3. Click Options Tool_Options_Standard.gif > Search,and select Schedule dissection daily to automatically dissect files in search paths.
  4. Set a Daily Start Time and Daily Stop Time to run the Design Clipart dissection (default is 11p.m. start).

    Task Scheduler runs the dissection task at the scheduled time.

    If a daily dissection is missed by over two hours, Design Clipart does not try to run that same scheduled dissection the following day. For example, you set the dissection start time to 11p.m., but you power down the computer at 6p.m. When you power up the computer the next morning at 9a.m., the missed 11p.m. dissection from the night before does not run.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Design Clipart with SolidWorks Task Scheduler
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21