Hide Table of Contents

Costing for Weldments

You can use SOLIDWORKS Costing to cost multibody weldments or single-body structural members.

With Costing, you can:

  • Open a multibody weldment or a single-body structural member. If the body contains a Structural Member in the FeatureManager design tree, the Costing software will automatically cost the structural member as an extruded part.
  • Cost either per length or per stock length.
  • Multibody templates support weld beads and fillet beads cost information. The cost for fillet beads is applied to all fillet beads. The cost for weld beads is automatically chosen based on weld bead information.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Costing for Weldments
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46