Hide Table of Contents

Inserting Weldment Cut List Tables in Drawings

To insert a weldment cut list table into a drawing:

  1. In a drawing, click Weldment Cut List Tool_Weldment_Cut_List_Table.gif (Table toolbar) or Insert > Tables > Weldment Cut List.
  2. Select a drawing view.
  3. Specify properties in the Weldment Cut List PropertyManager, then click PM_OK.gif.
  4. If you did not select Attach to anchor point in the PropertyManager, click in the graphics area to place the cut list.
    You can insert multiple cut lists in a drawing sheet.
    Be sure to trim structural members in the part document so that correct lengths appear on the cut list in the drawing. For example, use Trim/Extend tool_Trim_Extend_Weldment.gif (Weldments toolbar) to trim both ends of the cross member flush with the faces of the side members so the correct length (270) appears on the cut list.
    Before trimming
    After trimming

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Inserting Weldment Cut List Tables in Drawings
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.