Hide Table of Contents

Drawing Views

Contents

  • Center Mark Scaling

    You can turn off the view scale that is applied to center marks.

  • Hatch Patterns

    New DIN ISO 128-50 crosshatch types are available in the Area Hatch/Fill tool.

  • Model Break Views Within Drawings

    Use the Model Break View tool to create configuration-based 3D break views (also known as interrupted views) of a model for individual drawing views.

  • Section Views

    Standard without connector is a cutting line display for section views that complies with the ISO 128 standard.

  • View Arrow Letters



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Drawing Views
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20