Hide Table of Contents

Draw PLC

The graphical representation of the PLC components can be obtained in three ways.

 

- The first consists of launching the graphical representation of the modules in the new drawings from the PLC management. All channels will be drawn.

 

- The second method involves using the Insert PLC command in the PLC management and the Schematic menu. This method allows all or part of a module to be inserted into the drawing of your choice.

 

- The third method uses symbol insertion from a component;

 

PLC component representation is based on configuration settings for the page layout and symbol customization.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Draw PLC
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48