Hide Table of Contents

Multiple copy

Menu: Modify > Multiple copy

 

Creates multiple copies of selected entities.

 

When inserting multiple copies into the active file or drawing, the dockable panel displays available options.

 

Ends the command.

Validates the selection.

 

Select the items to copy, then specify the base point and endpoint.

 

Enter coordinates: Enter a value for the X and Y coordinates. These coordinates must be separated by a comma. Example: 150,125.

Distance: You can enter a length for the copy. Use this syntax (Line length<Angle). Example: 100<45.

This example copies the selected entities to 100 units and with an angle of 45°.

 

Note: When you use this command on symbols, wires, and other electrical schematic entities, the electrical project database is automatically updated.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Multiple copy
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.