Inserting a New Design Table (continued)

  1. Click each dimension value in the graphics area, in the order shown in the list below, to insert the remaining dimension names and values into the worksheet.
    Dimension Name (Table Cell) Dimension Value (Table Cell)
    box_height@Sketch1 (C2) 120 (C3)
    box_depth@Sketch1 (D2) 50 (D3)
    knob_dia@Sketch2 (E2) 70 (E3)
    knob_depth@Sketch2 (F2) 25 (F3)
    hole_dia@Sketch3 (G2) 50 (G3)
    fillet_radius@Outside_corners (H2) 10 (H3)
    If you see $STATE@ followed by a feature name in a column header cell, you selected a face instead of a dimension value in the graphics area. To replace a feature name with a dimension name, click the cell in the worksheet, then double-click the correct dimension value in the graphics area.

    The worksheet should now match the images below.

    design_table_3_left_dt _tut.png

    design_table_3_right_dt _tut.png

  2. Name the rows (cells A4:A6) blk2, blk3, and blk4. These are the names of the new configurations that you will create.