Creating a Face Fillet

In this section, you blend some of the faces using a face fillet with a hold line. For a face fillet, you can specify the radius between faces, or you can specify a hold line.

When you specify a hold line, the face that shares an edge with the hold line is removed. The radius of the fillet is determined by the position of the hold line relative to the selected faces.

  1. Click Fillet on the Features tab.
  2. In the PropertyManager, under Fillet Type click Face Fillet .
  3. Under Items To Fillet:
    1. Click in Face Set 1 .
    2. In the graphics area, select the face labeled below as Face Set 1.
    3. Click in Face Set 2 .
    4. In the graphics area, select the face labeled below as Face Set 2.
  4. Under Fillet Parameters:
    1. Select Hold Line for Fillet Method.
    2. Click in Hold Line Edges.
    3. In the graphics area, select the edge labeled below as Hold Line.
  5. Click , then click File > Save to This PC.