Hide Table of Contents

'OSNAP

Defines object snap points.

 

You can specify object snap points at END[point], CEN[ter], NEA[rest], or MID[point] of objects. When you draw objects in this mode, the pointer snaps to the specified points.

You can specify more than one OSNAP mode at the same time (END and MID, for example, or END, MID, CEN). However, when you specify a mode, previous modes are automatically turned off.

Turn off all OSNAP modes by entering the mode NONE.

See also 'SNAP, 'GRID, 'ORTHO, Transparent Commands.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   'OSNAP
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26