Hide Table of Contents

Insert Spline Point

The Insert Spline Point command adds one or more points to splines.

With spline points, you can:

  • Use spline points as handles to pull the spline into the shape you want.

  • Add dimensions between spline points or between spline points and other entities.

  • Add relations to spline points.

To insert spline points:

  1. In Edit Sketch mode, right-click a spline and select Insert Spline Point, or click Insert Spline Point (Spline Tools toolbar).

    The pointer changes to . If the pointer is not on the spline, the pointer changes to .

  2. Click one or more places on the spline where you want to insert a point.

To delete spline points:

    In an open sketch, select a point and press Delete.

Related Topics

Editing Splines

Adding Controls to Splines

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Insert Spline Point
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.