Hide Table of Contents

Ellipse

Use the Ellipse tool to create a complete ellipse. Use the Partial Ellipse tool to create an elliptical arc.

To create an ellipse:

  1. Click Ellipse art\ELLIPSE.gif on the Sketch toolbar, or Tools, Sketch Entities, Ellipse.

The pointer changes to art\pointer4ellipse.gif.

  1. Click in the graphics area to place the center of the ellipse.

  2. Drag and click to set the major axis of the ellipse.

  3. Drag and click again to set the minor axis of the ellipse.

To change the properties of an ellipse:



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Ellipse
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26