Hide Table of Contents

Using Select Connected Faces

Use the Select Connected Faces pop-up toolbar to help select connected faces in models.

To use Select Connected Faces:

  1. Right-click a face and choose Select Connected Faces.

    A pop-up toolbar appears to help you select faces to move.

  2. Hover over the toolbar images to highlight the possible selections in the model. Select an image, for example, All co-planar.

    The following selection choices are available:

    • All co-planar
    • All inner loops
    • All outer and inner loops
    • All surrounding
    • All tangent
    • All co-planar and connected faces
    • All co-directional full cylindrical/conical
    • All concentric full cylindrical/conical

    The software selects all co-planar faces.

  3. Use commands, such as fillet, to manipulate the selected faces.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Select Connected Faces
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.