Hide Table of Contents

Linearized Buckling Analysis

Slender models tend to buckle under axial loading. Buckling is defined as the sudden deformation which occurs when the stored membrane (axial) energy is converted into bending energy with no change in the externally applied loads. Mathematically, when buckling occurs, the stiffness becomes singular. The Linearized buckling approach, used here, solves an eigenvalue problem to estimate the critical buckling factors and the associated buckling mode shapes.

A model can buckle in different shapes under different levels of loading. The shape the model takes while buckling is called the buckling mode shape and the loading is called the critical or buckling load. Buckling analysis calculates a number of modes as requested in the Buckling dialog. Designers are usually interested in the lowest mode (mode 1) because it is associated with the lowest critical load. When buckling is the critical design factor, calculating multiple buckling modes helps in locating the weak areas of the model. The mode shapes can help you modify the model or the support system to prevent buckling in a certain mode.

A more vigorous approach to study the behavior of models at and beyond buckling requires the use of nonlinear design analysis codes.

When to Use Buckling Analysis

Slender parts and assemblies with slender components that are loaded in the axial direction buckle under relatively small axial loads. Such structures can fail due to buckling while the stresses are far below critical levels. For such structures, the buckling load becomes a critical design factor. Buckling analysis is usually not required for bulky structures as failure occurs earlier due to high stresses.

Related Topics

Buckling Load Factor

Performing Buckling Analysis

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Linearized Buckling Analysis
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.