Hide Table of Contents

Linear Sketch Patterns PropertyManager

Create linear sketch patterns using sketch entities on a plane or on a model. General guidelines include:

  • Pre-select entities to pattern, and you can select to pattern along either axis by setting a value for Number of Instances .

  • Select the X-axis, a linear entity, or a model edge to define Direction 1.

  • Repeat for Direction 2 ( Y-axis), which is activated as soon as you select Direction 1.

Direction 1

  • Reverse direction .

 

  • Spacing . Sets distance between the pattern instances.

  • Dimension X spacing. Displays dimension between the pattern instances.

  • Number of Instances . Sets the number of pattern instances.

  • Display instance count. Shows the number of instances in the pattern.

 

  • Angle . Sets an angular direction from the horizontal (X axis).

Linear pattern along X-axis set at 10o

Direction 2

  • Activates Direction 2 settings when you set a value for Number of Instances .

  • Dimension angle between axes. Displays dimension for the angle between the patterns.

The value of the angle along Y axis depends on the direction of the pattern along the Y axis, and the value you set for the angle along the X axis.

Linear pattern along X and Y axes with 100o off the Y axis

Entities to Pattern

Select sketch entities in the graphics area for Entities to Pattern .

Instances to Skip

Click Instances to Skip and with the pointer , select instances in the graphics area that you do not want to include in the pattern.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Linear Sketch Patterns PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.4