Hide Table of Contents

Adding Slopes for Pipe Routes

Routing provides full support for adding slopes to segments of solid pipe routes.

You define a slope by specifying the gravity plane, the start point, the direction of the slope, and the slope value. The slope becomes a property of the route segment.

wn2013_add_slopes3

If one end of the pipe route is fixed, then vertical segments of the route are shortened or lengthened to accommodate the sloped pipe segment. If the other end of the pipe route is not fixed, then the entire pipe route, including the fittings, are adjusted to move up or down.

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Slopes for Pipe Routes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59