Hide Table of Contents

Creating Drawings for Flexible Tubing Routes

You can create a drawing of a flexible tube assembly in the same manner as you create a pipe drawing. Tube drawings can include fittings, tubes, dimensions, and a BOM in an isometric view. You can also create drawings of tube routes that contain spools.

To create a tube drawing, click Tube Drawing tube_drawing (Flexible Tubing toolbar) or Routing > Flexible Tubing > Tube Drawing.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Drawings for Flexible Tubing Routes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.24