The sequence of diagnosis error messages for holes is as follows.
Contents
A planar face cannot be a hole.
The spline face is not axisymmetric.
The face does not represent a valid hole size.
There is a protrusion and a depression in the hole.
Other geometry is protruding into the hole.
The diameter of the hole is too large to recognize.
Multiple hole recognition is not supported.
The selection is not valid for hole recognition.
The face does not represent a valid hole.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2014 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.