Hide Table of Contents

Opening and Resolving Components

Selective Open and related tools are available on the Large Design Review tab of the CommandManager. These tools let you set some or all components to resolved or to lightweight.

The following commands cause the software to exit Large Design Review. You might notice a delay while component data is loaded. To return to Large Design Review, close and reopen the assembly.
tool_SelectiveOpen_LargeDesignReview.gif Selective Open In the Selective Open dialog box, select components to fully load. Other components are not loaded and become hidden.
tool_SelectiveOpenInLW_LargeDesignReview.gif Selective Open in Lightweight (on Selective Open flyout tool) In the Selective Open in Lightweight dialog box, select components to load as lightweight. Other components are not loaded and become hidden.
tool_SetAllResolved_LargeDesignReview.gif Set All to Resolved All components are fully loaded.
tool_SetAllLW_LargeDesignReview.gif Set All to Lightweight (on Set All to Resolved flyout tool) All components are loaded as lightweight.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Opening and Resolving Components
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.